![]() ![]() The amount of sand will depend on the style. Working in sand, silica sand is recommended, on top of the turf helps the turf stay in place. If it does not have drain holes it is recommended you create a slight grade to allow for water runoff. Some non-infill turfs have drain holes and that is indicated in the description. You can install a non-infill turf over compacted crushed stone. When installing padded turf outside, the pad will not break down but will retain some water, therefore, taking it longer to dry. You can not glue your turf to the existing carpet. When gluing to different surfaces it’s important to get the proper glue. We recommend you buy your turf glue, turf seam tape and sundries from TurfBond 77 or. The backing of both a non-padded or padded turf is made of polyurethane. When installing over a concrete pad or asphalt it is recommended you glue to install either a non-padded or padded turf. NON-infill turf can be installed inside or outside. If located in Pennsylvania or the surrounding area Mahantango Enterprises, 71 Liberty Tire Recycling is a nationwide crumb rubber distributor 70. It’s best to source crumb rubber pellet infill as close to the installation location to save on freight. Ideally filling with crumb rubber pellet infill to within 1/4” to the top of the blade. Using a fertilizer spreader and a plastic rake work in approximately 1 lb per sq ft of sand, silica sand is recommended and on top of sand work in approximately 2 lb per sq ft of crumb rubber pellet infill, to help hold turf in place and hold up turf blades. ![]() Infill turf has drain holes for adequate drainage.Ģ” tall infill sports turf installation instructions Prep your base: If located in Pennsylvania or the surrounding area, Mahantango Enterprises 71 It’s best to source crumb rubber pellet infill as close to the installation location as to save on freight. Using a fertilizer spreader and a plastic rake work in approximately 1 lb per sq ft of sand, silica sand is recommended and on top of sand work in approximately 1 lb per sq ft of crumb rubber pellet infill, to help hold turf in place and hold up turf blades. Low pile infill sports turf installation instructions Prep your base: Using a fertilizer spreader and a plastic rake work in approximately 1 to 1.5 lbs per sq ft of sand, silica sand is recommended, to help hold turf in place and hold up turf blades. Secure edges with landscape hooks or stakes, you can get at Home Depot. Using a turf seam kit (seam tape and glue) you can get from Home Depot or Turf Bond website, seam the pieces together. Make sure the grain of the grass fibers point in the same direction at installation. Position your turf and using a sharp razor knife trim selvage or trim to size from the backing of the turf. The blades of the turf should be pointing in the same direction when you roll out the rolls. Most are sold 15’ or 15’2” and although we don’t cut the width, we can cut your length(s). The lawn turf is sold in the width indicated on the website. Then fill in with crushed granite, limestone, OR #57 gravel. Lawn/Pet Turf Installation Instructions Prep your base:ĭig out approximately 3-4” of your ground and line with a weed barrier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |